|
Catalog No. |
Rev. |
Description |
|
1756sc-IF8H |
2.9 |
-
Fixed to send the
correct number of preambles.
-
Enhanced to
alternate short address 0 with other addresses for faster
initialization.
-
Fixed to keep
completed pass through responses when configuration changed.
-
Enhanced to no
longer block command 6.
-
Fixed to reduce the
number of clear configuration changed bit commands sent when the
configuration is being changed.
|
| |
|
|
|
1756sc-OF8H |
2.9 |
-
Fixed to send the
correct number of preambles.
-
Enhanced to
alternate short address 0 with other addresses for faster
initialization.
-
Fixed to keep
completed pass through responses when configuration changed.
-
Enhanced to no
longer block command 6.
-
Fixed to reduce the
number of clear configuration changed bit commands sent when the
configuration is being changed.
|
| |
|
|
|
1756sc-IF8H |
2.5 |
Fix software to be
HART version 5 compliant when decoding HART command #50. |
| |
|
|
|
1756sc-OF8H |
2.5 |
Fix software to be
HART version 5 compliant when decoding HART command #50. |
| |
|
|
|
1756sc-IF8H |
2.3 |
Addition
of user selectable unconnected messaging scheduling. This
allows the user to determine the rate that the pass-through
message queue is serviced. Service rate may be set higher
when used with CONNECTS gateway to optimize performance |
| |
|
|
|
1756sc-OF8H |
2.3 |
Addition of user
selectable unconnected messaging scheduling. This allows the
user to determine the rate that the pass-through message queue is
serviced. Service rate may be set higher when used with
CONNECTS gateway to optimize performance |
| |
|
|
|
1756sc-IF8u |
2.4 |
CJC data
can freeze or drop out affecting data quality
Allow use of GSV to retrieve I/O fault |
|
1756sc-IF8u |
2.3 |
Add a
short circuit condition detection to the CJC sensor.
If the data ready signal is not received from the ADC within the
timeout for the filter chosen, reset the ADC. If the situation
remains for 3 samples, issue a HW fault and stop processing.
|
|
1756sc-IF8u |
2.1 |
RSLogix
V16 intermittent connection with extended RPI settings fixed.
Add-on profile major and minor revision support added. |
|
1756sc-IF8u |
1.33 |
When operating in 3-wire RTD/Resistance
mode, the lead resistance correction computation was
incorrect. The algorithm introduces a substantial error when the
sensor resistance changes. This error persists until the next
lead resistance measurement occurs. |
